Tektronix 067-0587-01 User Manual

CALIBRATION PROCEDURE 067-0587-01
g. Set the Signal Standardizer AMPLITUDE control to obtain a 4-
division display.
h. Adjust R31 to just turn CW LEVELED light on. If CW LEVELED light
doesn't go off, mechanically center R31 and check that the light remains on
while rotating the AMPLITUDE control to obtain from four (4) to eight (8)
divisions.
CW Leveled Check
i. Set the Signal Standardizer AMPLITUDE control to obtain a 6—division
display.
j. Increase the Constant Amplitude Signal Generator amplitude to
1 volt p-p. (Check that the display maintains approximately 6 divisions and
that the CW LEVELED light remains on.
k. Increase the Constant Amplitude Signal Generator to 3 volts p-p.
Check that the display is distorted and the CW LEVELED light extinquishes.
7. Frequency Response Check
a. Set the constant amplitude generator to 0.5 volts and adjust the
Signal Standardizer AMPLITUDE control to obtain a 6—division display.
b. Set the sampling sweep unit to 2 ns/division.
ec. Check that the display amplitude remains within 5.82 divisions to
6.18 divisions (+3%) while varying the frequency of the constant amplitude
signal*generator from 70 MHz to 500 MHz.
d. Remove all cables and test equipment.
This completes the calibration procedure for the 067-0587-01 Signal Stand-
ardizer.
4-15

Tektronix 067-0587-01 Specifications

General

Brand	Tektronix
Model	067-0587-01
Category	Test Equipment
Language	English