2445 Operators
OPERATORS SAFETY SUMMARY
The general safety information in this part o f the summary is for both operating and servicing personnel. Specific warnings
and cautions will be found throughout the manual where they apply and do not appear in this summary.
Terms in This Manual
CAUTION statements identify conditions or practices
that could result in damage to the equipment or other
property.
WARNING statements identify conditions or practices
that could result in personal injury or loss of life.
Grounding the Product
This product is grounded through the grounding conductor
of the power cord. To avoid electrical shock, plug the
power cord into a properly wired receptable before con
necting to the product input or output terminals. A
protective ground connection by way of the grounding
conductor in the power cord is essential for safe operation.
Terms as Marked on Equipment
CAUTION indicates a personal injury hazard not imme
diately accessible as one reads the markings, or a hazard to
property, including the equipment itself.
DANGER indicates a personal injury hazard immediately
accessible as one reads the marking.
Danger Arising From Loss of Ground
Upon loss of the protective-ground connection, all acces
sible conductive parts (including knobs and controls that
may appear to be insulating) can render an electric shock.
Symbols in This Manual
This symbol indicates where applicable
A
cautionary or other information is to be
found. For maximum input voltage see
Table 1-1.
Use the Proper Power Cord
Use only the power cord and connector specified for
your product.
Use only a power cord that is in good condition.
For detailed information on power cords and connectors
see Table 2-1.
Symbols as Marked on Equipment
DANGER — High voltage.
Protective ground (earth) terminal.
Use the Proper Fuse
To avoid fire hazard, use only a fuse of the correct type,
voltage rating and current rating as specified in the parts
list for your product.
A
ATTENTION — Refer to manual.
Power Source
This product is intended to operate from a power source
that does not apply more than 250 volts rms between the
supply conductors or between either supply conductor and
ground. A protective ground connection by way of the
grounding conductor in the power cord is essential for safe
operation.
Do Not Operate in Explosive Atmospheres
To avoid explosion, do not operate this product in an
explosive atmosphere unless it has been specifically cer
tified for such operation.
Do Not Remove Covers or Panels
To avoid personal injury, do not remove the product
covers or panels. Do not operate the product without the
covers and panels properly installed.
To Next Page
Loading...
Need help?
General
