AFG3000 Series Arbitrary/Function Generators Service Manual xv
Introduction
This manual contains information that is needed to properly service the AFG3000
Series Arbitrary/Function Generators as well as general information that is critical
to safe and effective servicing.
To prevent personal injury or damage to the arbitrary/function generator, consider
the following before attempting service:
The procedures in this manual should be performed only by a qualified service
person.
Read the General Safety Summary on page vii and the Service Safety Summary,
beginning on page ix.
Read Installation in Operating Basics on page 2-2.
When using this manual for servicing, be sure to follow all warnings, cautions, and
notes.
Performance Verification Procedures
The performance check described in the Performance Verification section should
be done every 12 months. In addition, a performance check is recommended after
module replacement.
If the AFG3000 Series does not meet performance criteria, repair is necessary.
Strategy for Servicing
Throughout this manual, the term, module, refers to any field-replaceable
component, assembly, or part of the arbitrary/function generator.
This manual contains the information needed for periodic maintenance of the
arbitrary/function generator. Further, it contains information for corrective
maintenance down to the module level. To isolate a failure to a module, use the
troubleshooting procedures found in the Maintenance section. To remove and
replace any failed module, follow the instructions in the Removal and Installation
Procedures subsection. After isolating a faulty module, replace it with a
fully-tested module obtained from the factory. The Replaceable Parts List section
contains part number and ordering information for all replaceable modules.
To Next Page
Loading...
Need help?
General
