Introduction
The CT-1 and CT-2 are high-frequency, bidirectional current probes. The CT-1 is
a 1 GHz current probe and the CT-2 is a 200 MHz current probe. Each current
probe comes with a P6041 probe cable to allow you to connect directly to an
oscilloscope to take measurements.
Figure 1: CT-1 current probe
WARNING. To avoid electric shock, do not exceed the b are wire voltage ratings
(30 VAC or 42 Vpk). Depending on which instrument the CT-1 or CT-2 is
connected to, the exposed current transformer case metal may be floating
(elevated above earth potential). Whenever possible, connect the mounting stud
to earth ground.
The chassis ground symbol (
) as shown on the product indicates that the
exposed current transformer c ase metal may not be connected to earth ground.
Use caution when the probe is not grounded.
The CT-1 and CT-2 are available as separately purchased units (Option 09). The
Replaceable Parts List contains ordering information. (See page 11.)
This manual provides information on four subjects:
Description
Operation
Specifications
Re
placeable Parts List
CT-1 and CT-2 Current Transformer Instructions 1
To Next Page
Loading...