Installation
Humidity:
5% to 95% relative humidity
Cleaning
Inspect the oscilloscope and probes as often as operating conditions require. To clean the exterior surface, perform the following
steps:
1. Remove loose dust on the outside of the oscilloscope and probes with a lint-free cloth. Use care to avoid scratching the clear
glass display filter.
2. Use a so ft cloth dampened with water to clean the oscilloscope. Use an aqueous solution of 75% isopropyl alcohol for
more efficient cleaning.
CAUTION. To avoid damage to the s urface of the oscilloscope or probes, do not use any abrasive or chemical cleaning agents.
DPO2000 and MSO2000 Series Oscilloscopes User Man ual 11
To Next Page
Loading...
Need help?
General
