Trigger Setup
IfyouhavemadeaTrigger On selection of
Data or Address/Data, push the lower-bezel
Data button to access the I
2
C D ata side-bezel
menu.
Push the Number of Bytes butto n an d enter
the num ber of bytes with multipurpose knob a.
Push the side-bezel Addressing Mode button
and select 7bitor 10 bit. Push the side-bezel
Data button. Enter the data parameters of
interest with multipurpose knobs a and b.
For more information o n the I
2
C address
formats, refer to item 2 under Setting Up Bus
Parameters.
150 MSO4000 and DPO4000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
