Trigger Setup
8. If you are setting up an SPI trigger and have
made a Trigger O n selection of MOSI or
MISO, push the lower-bez el Data button, push
the side-beze l MOSI (or MISO) bu tton, and
enter the data parameters of int erest with
multipurpose knobs a and b.
Then push the Number of Bytes button and
enter the number of bytes with multipurpose
knob a.
If you select MOSI & MISO, push the
lower-bezel Data button and enter the
parameters of interest in the side-bezel menus.
MSO4000 and DPO4000 Series Oscilloscopes User Manual 151
To Next Page
Loading...
Need help?
General
