System information
You can display serial number, firmware revision, and calibration dates through the front panel by selecting
SYSTEM-INFO from the main menu.
To view the system information from the front panel:
1. Press the MENU key.
2. Select SYSTEM-INFO.
3. Select one of the following:
▪ FIRMWARE
▪ SERIAL#
▪ CAL
For remote programming, use the *IDN? query to read system information.
Beeper
The 2601B-PULSE includes a beeper. When it is enabled, a beep indicates one of the following actions have
occurred:
▪ A front-panel key was pressed: A short beep, similar to a key click, is issued.
▪ The navigation wheel was turned or pressed: A short beep is issued.
▪ The output source was changed: A longer beep is issued when you select the OUTPUT ON/OFF control
(turn the output on or off).
To turn the beeper on or off from the front panel:
1. Press the MENU key, and then select BEEPER.
2. Select one of the following:
▪ ENABLE
▪ DISABLE
To turn the beeper on or off from the TSP command interface:
Set the beeper.enable attribute. For example, to enable the beeper, send:
beeper.enable = 1
To Next Page
Loading...
