Tektronix MDO3000 Series Demonstration Guide

Rare Anomaly
Board label: RARE_ANOM
Grid location: A10
Description: The two less-frequent
anomalies in this pulse train can show up on
high waveform capture rate oscilloscopes.
A half-height runt signal occurs
approximately every 838.8 ms. Use a Runt
trigger to isolate the signal.
A 25 ns (narrow) pulse appears in
approximately 838.8 ms. Use a Pulse Width
trigger to isolate the signal.
The pulse train is a repeating group of three
pulses. The three pulses are 100 ns, 200 ns,
and 100 ns wide, with a 100 ns low between
each pulse. The group repeats at a 1.6 μs
rate.
The anomaly is a group of four pulses. The
four pulses are 50 ns, 25 ns (narrow), 100 ns
(runt), and 100 ns wide, with a 100 ns low
between each pulse, except for a 25 ns low
before the narrow pulse.
Reset Button
Board label: RESET
Grid location: B7
Description: Press this button to start all
generated signals from a common point.
RF Output
Board label: None
Grid location: H9
Description: Use the RF output from this
connector in the seven different RF demos
controlled by the Mode button. Directly
connect this output to the RF input of the
MDO3000 Series oscilloscope.
www.tektronix.com/mdo3000 49
MDO3000 Series Oscilloscope
Demonstration Guide

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English