Built-In Security Features
The LAN system i
s disabled and no longer allows data traffic in o r out. The
relevant LAN Ethernet settings are also cleared.
Disable the USB Device Port
To disable the USB device port, follow these steps:
1. Remove any U
SB cable or device from the USB device port on the rear of the
instrument.
2. Push the fr
ont-panel Utility button.
3. Push the Utility Page lower-bezel button and use the Multipurpose a knob
to select
I/O.
4. Push the USB lower-bezel button.
5. Push the Disabled (Off Bus) side-bezel button to disable the USB device port.
Note that the USB lower-bezel button shows “Disabled.” The USB device port is
disabled and no longer allows data trafficinorout.
10 MDO4000 Series Oscilloscopes and Application Modules Declassification and Security Instructions
To Next Page
Loading...
