Need help?Do you have a question about the Tektronix MSO70404C and is the answer not in the manual?
General| Bandwidth | 4 GHz |
|---|---|
| Channels | 4 |
| Sample Rate (Digital) | 10 GS/s |
| Operating System | Windows |
| Probe Interface | TekVPI |
| Display | 12.1 in. color TFT LCD |
| Vertical Resolution | 8 bits |
| Input Impedance | 50 Ω or 1 MΩ |
| Maximum Input Voltage (50 Ω) | 5 Vrms |
| Maximum Input Voltage (1 MΩ) | 400 V peak |
| Trigger Types | Edge, Pulse, Runt, Timeout, Window, Logic, Video |
Review safety precautions to avoid injury and prevent damage.
Use proper power cord, ground product, disconnect power, connect/disconnect properly.
Information for safely performing service procedures by qualified personnel.
Explains how to prevent Electrostatic Discharge damage to the instrument.
Lists power supply requirements and power consumption for different series.
Procedure to perform signal path compensation for accurate measurements.
Steps to connect probes and select input channels for signal acquisition.
Explains trigger events, modes (Normal, Auto), and trigger holdoff.
Using A Event trigger for simple signals and B Event for complex signals.
How to select channels and choose measurements in five categories.
How to compare signals to predefined templates or masks for testing.
How to compare active signals with template waveforms for pass/fail testing.
Using FastAcq to find and capture intermittent anomalies in signals.
How to set up bus triggers for I2C, SPI, RS-232, USB, CAN, and parallel buses.
To Next Page
