â–
Opt. CA1 - Provides single calibration event for the designated interval
â–
Opt. R3 - Repair service 3 years (including warranty)
â–
Opt. R5 - Repair service 5 years (including warranty)
â–
Software:
MSO70000C/DX, and DPO70000C/DX Series:
â–
Opt. BRR - BroadR-Reach Compliance Testing
â–
Opt. DDRA - DDR Memory Bus Analysis
â–
Opt. DJA - Advanced Jitter and Eye Analysis (standard on MSO instruments)
â–
Opt. D - PHY MIPI D-PHY Transmitter Debug, Characterization, and Compliance Test Solution (requires DJA)
â–
Opt. DP12 - DisplayPort 1.2 Source Test Automation (requires Opt. DJA and Opt.5XL or higher)
â–
Opt. ERRDT - Frame and Bit Error Rate Detector in high speed serial standards (requires option ST6G).
â–
Opt. ET3 - Ethernet Compliance Test
â–
Opt. HSIC – HSIC Essentials - Electrical Validation and Protocol Decode Solution (Requires Opt. DJA)
â–
Opt. HT3 - HDMI Compliance Test
â–
Opt. HT3DS - HDMI Direct Synthesis for HDMI 1.4 Compliance Test
â–
Opt. M - PHY - MIPI M-PHY Essentials – Characterization and Analysis Solution (Requires Opt. DJA)
â–
Opt. M - PHYTX - M-PHY Automated Transmitter Solution (requires DJA)
â–
Opt. M - PHYRX - M-PHY Automated Receiver Solution (Requires Opt. ST6G) (Requires Opt. ERRDT)
â–
Opt. MTH - Mask Testing for serial standards, 4.25 GB/s (standard on MSO instruments)
â–
Opt. MOST - Electrical Compliance and Debug Test Solution for MOST50 and MOST150 (Requires Opt. DJA)
â–
Opt. PCE3 - PCI Express
®
Transmitter Compliance and Debug (Requires Opt. DJA) (For models of bandwidth ≥6 GHz
only)
â–
Opt. PWR - DPOPWR Power Measurements and Analysis
â–
Opt. QPI - Intel
®
Quick Path Interconnect Test Automation Software (Requires Opt. DJA)
â–
Opt. SAS3 - SAS3 12 GB/s Essentials (Requires Opt. DJA and 2XL or higher) (For models of bandwidth ≥20 GHz only)
â–
Opt. SFP-TX - SFP+ Compliance and Debug Solution (Requires Opt. DJA)
â–
Opt. SFP-WDP - SFP+ Compliance and Debug Solution – WDP Measurement (Requires Opt. DJA)
â–
Opt. SDLA64 - Serial Data Link Analysis Visualizer
â–
Opt. SR-AERO - MIL-STD-1553 Serial Triggering and Analysis
â–
Opt. SR-AUTO - Automotive Serial Triggering and Analysis (CAN, LIN, FLEXRAY)
â–
Opt. SR-COMP - Computer Serial Triggering and Analysis (RS-232/422/485/UART)
â–
Opt. SR-DPHY - MIPI-D-PHY (DSI1/CSI2) Serial Analysis
â–
Opt. SR-EMBD - Embedded Serial Triggering and Analysis (I2C, SPI) (standard on MSO instruments)
â–
Opt. SR-ENET - Ethernet Serial Analysis (10BASE-T and 100BASE-TX)
â–
Opt. SR-PCIE - PCI Express Compliance Module for RT-Eye Serial Data Compliance and Analysis
â–
Opt. SR-USB - USB Serial Triggering and Analysis (LS, FS, HS)
About Tektronix oscilloscopes
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 13