Compliance information
Canadian certification
CAN/CSA-C22.2
No. 61010-1. Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use – Part 1: General
Requirements.
CAN/CSA-C22.2 No. 61010-2-032. (TCP305A/312A only) Particular
requirements for handheld and hand manipulated current sensors for electrical
measurement and test equipment.
Additional compliances
IEC 61010-1. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 1: General Requirements.
IEC 61010-2-032. (TCP303/305A/312A/404XL only) Particular
requirements for handheld current clamps for electrical measurement and
test equipment.
Equipment type
Test and measuring equipment.
Safety class
TCPA300/400 only: Class 1 – grounded product.
Pollution degree
descriptions
A measure of the contaminants that could occur in the environment a round
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
Pollution degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally enc apsulated, hermetically sealed, or
located in clean rooms.
Pollution degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
Pollution degree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.
P
ollution degree rating
Pollution degree 2 (as defined in IEC 61010-1). Rated for indoor, dry location
use only.
IP rating
IP20 (as defined in IEC 60529).
8Amplifiers a nd Current Probes Compliance and Safety Instructions
To Next Page
Loading...
Need help?
General
