Compliance information
return lead as s
hort as possible and close to the probe body. Some probes have accessory probe tip adapters to
accomplish this most effectively. In all cases, observe all safety instructions for the probes or leads used.
4
For complianc
e with the EMC standards listed here, high quality shielded interface cables that incorporate low
impedance connection between the cable shield and the connector shell should be used.
EMC compliance
Meets the intent of Directive 2014/30/EU for Electromagnetic Compatibility
when it is use
d with the product(s) stated in the specifications table. Refer to the
EMC s peci fi cation published for the stated products. May not meet the intent of
the directive if used with other products.
Australia / New Z ealand
EMC
Complies w
ith the EMC provision of the Radiocommunications Act per the
following standard, in accordance with ACMA:
EN 61326-
1 and EN 61326-2-1. Radiated and Conducted Emissions, Group 1,
Class A.
Safety c
ompliance
This section lists the safety standards with which the product complies a nd other
safety compliance information.
EU low v
oltage directive
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Union:
Low Voltage Directive 2 014/35/EU.
EN 61010-1. Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use – Part 1: General Require me nts .
EN 61010-2-032. (TCP303/305A/312A/404XL only) Particular requirements
for handheld current clamps for electrical measurement and test equipment.
U.S. nation ally recognized
testing laboratory lis ting
UL 61010-1. (TCPA300/400 and TCP305A/312A only) Safety Requirements
for Electrical Equipment for Measurement, Control, and Labora t ory Use –
Part 1: General Requirements.
UL 3111-1. (TCP303/404XL only) Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use – Part 1: General
Requirements.
UL 61010-2-032. (TCP305A/312A only) Particular requirements for
handheld current clamps for electrical measurement and test equipment.
IEC 3111-2-032. (TCP303/404XL only) Particular requirements for handheld
current clamps for electrical measurement and test equipment.
Amplifiers a nd Current Probes Compliance and Safety Instructions 7
To Next Page
Loading...
Need help?
General
