Important safety information
Power disconne
ct. TCPA300/400 only: The power cord disconnects the product
from the power source. See instructions for the location. Do not position
the equipment so that it is difficult to operate the power cord; it must remain
accessible to the user at all times to allow for quick disconnection if needed.
Connect and disconnect properly. TCPA300/400 only: Do not connect or
disconnect
probes or test leads while they are connected to the circuit.
Use only current probes, test leads, and adapters supplied with the product, or
indicated
by Tektronix to be suitable for the product.
Observe all terminal ratings. TCPA300/400 only: To avoid fire or shock hazard,
observe all ratings and markings on the product. Consult the product manual for
further ratings information before making connections to the product.
Do not apply a potential to any terminal, including the common terminal, that
exceeds the maximum rating of that terminal.
Do not o
perate without covers. Do not operate this product with covers or panels
removed, or with the case open. Hazardous voltage exposure is possible.
Avoid exposed circuitry. Do not touch exposed connections and components
when power is present.
Do no
t operate with suspected failures. TCPA300/400 only: If you suspect that
there is damage to this product, have it inspected by qualified service personnel.
Dis
able the p roduct if it is damaged. Do not use the product if it is damaged
or operates incorrectly. If in doubt about safety of the product, turn it off and
disconnect the power cord. Clearly mark the product to prevent its further
operation.
Before use, inspect current probes, test leads, and acc essories for mechanical
damage and replace when damaged. Do not use probes or test leads if they are
damaged, if there is exposed metal, or if a wear indicator shows.
Examine the exterior of the product before you use it. Look for cracks o r missing
pieces.
Use only specified replacement parts.
Do not operate in wet/damp conditions. Be aware that condensation may occur if
a unit is moved from a cold to a warm environment.
Do not operate in an explosive atmosphere.
Keep product surfaces clean and dry. Remove the input signals before you clean
the product.
2Amplifiers a nd Current Probes Compliance and Safety Instructions
To Next Page
Loading...
Need help?
General
