Command Descriptions
2–78
TDS Family Oscilloscope Programmer Manual
!
specifies the first paired cursor.
specifies the second paired cursor.
selects the second paired cursor as the active cursor.
returns when the first paired cursor is the active cursor.
CURSor:PAIred:UNIts
Sets or queries the units for the paired cursors. This is equivalent to setting
Amplitude in the Cursor menu.
Cursor
!
specifies base as the unit of measure.
specifies IRE as the unit of measure. These units are typically used with
video signals.
Syntax
Arguments
Examples
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
