Command Descriptions
2–90
TDS Family Oscilloscope Programmer Manual
Cursor
CURSor:FUNCtion
CURSor:PAIred:VDELTA?
CURSor
:
PAIred :
?
VDELTA
CURSOR:PAIRED:VDELTA?
might return 1.064E+00, indicating that the time between the paired cursors is
1.064 seconds.
CURSor:VBArs
Positions the vertical bar cursors and the CURSor:VBArs? query returns the
current vertical bar cursor settings for horizontal position, delta, cursor selection,
and units.
The position can appear in units of seconds, 1/seconds (hertz), or video line
numbers (with option 05). On the TDS 400A, position can also appear in units of
clocks or 1/clocks.
In extended-acquisition-length mode, the cursors are limited to the waveform
record section of the acquisition data (see Figure 2–4 on page 2–41).
Cursor
DATa:STARt, DATa:STOP, MEASUrement:GATing
CURSor:VBArs SNAp
CURSor:VBArs?
CURSor
:
VBArs
<Space>
?
SNAp
SNAp positions the vertical bar cursors at DATa:STARt and DATa:STOP.
Group
Related Commands
Syntax
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
Need help?
General
