Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–181
LIMit:BELl
Rings the bell when the waveform data exceeds the limits set in the limit test, if
the limit state is on.
Limit Test
LIMit:COMPARE:CH<x>, LIMit:STATE
or = 0 turns off ringing the bell when any waveform data exceeds the
limits set by the limit test.
or 0 turns on ringing the bell.
specifies that the bell is to ring when any waveform data exceeds the limits
specified in the limit test.
returns either or , indicating whether the bell is to ring when any waveform
data exceeds the limits specified in the limit test.
LIMit:COMPARE:CH<x>
Sets or queries the template against which to compare the waveform acquired
through the specified channel. The template can be a waveform saved in any of
the reference locations REF1 through REF4, or none.
Limit Test
Group
Related Commands
Syntax
Arguments
Examples
Group
To Next Page
Loading...
Need help?
General
