Command Descriptions
2–184
TDS Family Oscilloscope Programmer Manual
or 0 turns on the hardcopy operation for the waveform when any
waveform data exceeds the limits set by the limit test.
or = 0 turns off the hardcopy operation.
specifies that the hardcopy operation occurs for the waveform when any
waveform data exceeds the limits specified in the limit test.
returns either or , indicating whether the hardcopy operation occurs for the
waveform when any waveform data exceeds the limits specified in the limit test.
LIMit:STATE
Turns limit testing on or off, or queries whether limit testing is in effect.
When extended–acquisition–length mode or InstaVu mode is on, this command
can still set and return values. However, this feature will not actually function.
You cannot turn limit:state to on when extended–acquisition-length mode is
already on.
Limit Test
CURve, LIMit:BELl, LIMit:COMPARE:CH<x>, LIMit:HARDCopy, LIM-
it:TEMPLate, WFMPre
or = 0 turns off limit testing.
or 0 turns on limit testing.
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
Need help?
General
