Tektronix TDS 500C Programmer's Manual

Command Descriptions
2–272
TDS Family Oscilloscope Programmer Manual
Trigger
HORizontal:DELay:MODe, HORizontal:DELay:TIME:RUNSAfter,
HORizontal:DELay:TIME:TRIGAfter
TRIGger:DELay:TIMe <NR3>
TRIGger:DELay:TIMe?
TRIGger :
:
DELay
?
<Space>
<NR3>
TIMe
<NR3> is the delay time, in seconds.
TRIGGER:DELAY:TIME 4E-6
sets the delay time to 4 ms.
TRIGger:DELay:TYPe
Sets or queries the type of delayed trigger.
Trigger
TRIGger:DELay:TYPe EDGE
TRIGger:DELay:TYPe?
TRIGger :
:
DELay
?
<Space>
TYPe
EDGE
EDGE is a normal trigger. A trigger event occurs when a signal passes through a
specified voltage level in a specified direction. Use the TRIGger:DELay:LEVel
and TRIGger:DELay:EDGE:SLOpe commands to set the voltage level and
direction respectively.
TRIGGER:DELAY:TYPE?
always returns EDGE as the type of delayed trigger.
Group
Related Commands
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples

Tektronix TDS 500C Specifications

General

Brand	Tektronix
Model	TDS 500C
Category	Test Equipment
Language	English