Tektronix TDS 500C Programmer's Manual

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–275
TRIGger:MAIn:COMMunication:AMI:THReshold:LOW
TDS 500C & 700C Only
Sets or queries the AMI communication trigger’s low threshold value in volts.
Trigger
TRIGger:MAIn:COMMunication:AMI:THReshold:LOW <NR3>
TRIGger:MAIn:COMMunication:AMI:THReshold:LOW?
TRIGger :
:
MAIn :
<Space>
?
COMMunication
LOW
:
THReshold
<NR3>
AMI
:
<NR3> is the low value of the threshold. The unit of measure is volts. The default
is –0.5 volts.
TRIGGER:MAIN:COMM:AMI:THRESHOLD:LOW 2.8 E–2
sets the low threshold to 28 milliVolts.
TRIGger:MAIn:COMMunication:BITRate
TDS 500C & 700C Only
Sets or queries the communication trigger signal bit rate. If this command
changes the bit rate, the command then also causes the communication standard
to set to “custom”. If both the TRIGger:MAIn;COMMunication:STANDard
command and the TRIGger:MAIn;COMMunication:BITRate command are used,
the last one executed takes precedence.
Trigger
TRIGger:MAIn:COMMunication:BITRate { <NR3> }
TRIGger:MAIn:COMMunication:BITRate?
Group
Syntax
Arguments
Examples
Group
Syntax

Tektronix TDS 500C Specifications

General

Brand	Tektronix
Model	TDS 500C
Category	Test Equipment
Language	English