Command Descriptions
2–282
TDS Family Oscilloscope Programmer Manual
E1 refers to E1 (2.048 Mb/s) AMI standard.
E2 refers to E2 (8.44 Mb/s) AMI standard.
E3 refers to E3 (34.368 Mb/s) AMI standard.
E4 refers to E4 (139.26 Mb/s) CMI standard.
E5 refers to E5 or CEPT (565 Mb/s) NRZ standard.
STS1 refers to STS–1 (51.84 Mb/s) AMI standard.
STS3 refers to STS–3 (155.52 Mb/s) CMI standard.
OC1 refers to OC1/STM0 (51.84 Mb/s) CMI standard.
OC3 refers to OC3/STM1 (155.52 Mb/s) NRZ standard.
OC12 refers to OC12/STM4 (622.08 Mb/s) NRZ standard.
STM1E refers to STM1E (155.52 Mb/s) CMI standard.
FC133 refers to FC133 (132.7 Mb/s) NRZ standard.
FC266 refers to FC266 (265.6 Mb/s) NRZ standard.
FC531 refers to FC531 (531.2 Mb/s) NRZ standard.
FC1063 refers to FC1063 (1.063 Gb/s) NRZ standard.
FDDI refers to FDDI (125 Mb/s) NRZ standard.
D1 refers to 4:2:2 or D1 (270 Mb/s) NRZ standard.
D2 refers to 4fsc NTSC or D2 (143.18 Mb/s) NRZ standard.
CUSTom can take a non-standard, floating-point bit rate. <NR3>.
TRIGGER:MAIN:COMM:STANDARD E4
selects the E4 communication standard.
TRIGger:MAIn:EDGE? (Query Only)
Returns the trigger coupling, source, and slope for the main edge trigger.
Trigger
TRIGger:MAIn:EDGE?
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
