Command Descriptions
2–284
TDS Family Oscilloscope Programmer Manual
TRIGger:MAIn:EDGE:SLOpe
Selects a rising or falling slope for the main edge trigger. This is equivalent to
setting Slope in the Trigger menu.
Trigger
# $ %
specifies to trigger on the falling or negative edge of a signal.
specifies to trigger on the rising or positive edge of a signal.
sets the main edge trigger to occur on the rising slope.
TRIGger:MAIn:EDGE:SOUrce
Sets or queries the source for the main edge trigger. This is equivalent to setting
Source in the Trigger menu.
Trigger
# " (not available on TDS
520C &
TDS 724C) $ ! $ %
Group
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
