Hardcopy
Reference
3Ć66
5. Type: IBRDF <Filename>where <Filename> is a valid DOS file name
you want to call your hardcopy information. It should be
v
8 characters
long with up to a 3 character extension. For example, you could type
“ibrdf screen1”
.
6. Exit the IBIC program by typing: EXIT
7. Type: COPY <Filename> <Output port> </B> where <Filename> is the
name you defined in step 5 and <Output port> is the PC output port your
hardcopy device is connected to (such as LPT1 or LPT2). Copy the data
from your file to your hardcopy device. First, ensure your printer or plotter
is properly attached to your PC. Then copy the file. For example, if your
file is called
screen1
and your printer is attached to the
lpt1
parallel port,
type
“copy screen1 lpt1: /B”
.
NOTE
If you transmit hardcopy files across a computer network, use a
binary (8-bit) data path.
Your hardcopy device should now print a picture of the digitizing oscilloscope
screen.
See
Remote Communication
, on page 3-126.
For More
Information
To Next Page
Loading...
Need help?
General
