Tektronix TDS 520A - Example 1: Displaying a Waveform

TDS 620A, 640A, & 644A User Manual
1Ć7
Example 1: Displaying a Waveform
In this first example you learn about resetting the digitizing oscilloscope,
displaying and adjusting a waveform, and using the autoset function.
All examples in the tutorial begin by resetting the digitizing oscilloscope to a
known factory default state. Reset the oscilloscope when you begin a new
task and need to “start fresh” with known default settings.
1. Press the save/recall SETUP button to display the Setup menu (Fig-
ure 1-4).
SETUP Button
Figure 1-4: SETUP Button Location
The digitizing oscilloscope displays
main menus along the bottom of the
screen. Figure 1-5 shows the Setup main menu.
Recall Factory Setup
Menu Item and Button
OK Confirm Factory Init
Menu Item and Button
Figure 1-5: The Displayed Setup Menu
Resetting the
Digitizing
Oscilloscope