Tektronix TDS 520B Programming Manual

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–43
ACQUIRE:NUMACQ?
might return 350, indicating that 350 acquisitions took place since an AC-
QUIRE:STATE RUN command was executed.
ACQuire:NUMAVg
Sets the number of waveform acquisitions that make up an averaged waveform.
This is equivalent to setting the Average count in the Acquisition Mode side
menu.
Acquisition
ACQuire:MODe
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
NUMAVg
?
<Space> <NR1>
:ACQuire
<NR1> is the number of waveform acquisitions, from 2 to 10,000.
ACQUIRE:NUMAVG 10
specifies that an averaged waveform will show the result of combining 10
separately acquired waveforms.
ACQUIRE:NUMAVG?
might return 75, indicating that there are 75 acquisitions specified for averaging.
ACQuire:NUMEnv
Sets the number of waveform acquisitions that make up an envelope waveform.
This is equivalent to setting the Envelope count in the Acquisition Mode side
menu.
Acquisition
ACQuire:MODe
Examples
Group
Related Commands
Syntax
Arguments
Examples
Group
Related Commands

Tektronix TDS 520B Specifications

General

Brand	Tektronix
Model	TDS 520B
Category	Test Equipment
Language	English