Command Descriptions
2–160
TDS Family Oscilloscope Programmer Manual
Limit Test
LIMit:COMPARE:CH<x>, LIMit:STATE, HARDCopy
or 0 turns on the hardcopy operation for the waveform when any
waveform data exceeds the limits set by the limit test.
or = 0 turns off the hardcopy operation.
specifies that the hardcopy operation occurs for the waveform when any
waveform data exceeds the limits specified in the limit test.
returns either or , indicating whether the hardcopy operation occurs for the
waveform when any waveform data exceeds the limits specified in the limit test.
LIMit:STATE
Turns limit testing on or off, or queries whether limit testing is in effect.
Limit Test
CURve, LIMit:BELl, LIMit:COMPARE:CH<x>, LIMit:HARDCopy, LIM-
it:TEMPLate, WFMPre
Group
Related Commands
Syntax
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
