Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–175
specifies the rising edge.
specifies that the rising edge be used for the immediate delay measurement.
returns showing that the falling or negative edge of the waveform is used
for the immediate delay measurement.
MEASUrement:IMMed:SOURCE[1]
Sets or queries the source for all single channel immediate measurements and
specifies the source to measure “from” when taking an immediate delay
measurement or phase measurement.
Measurement
" # % $ & $ & $ '
" #
!
$
" #
$ is an input channel.
$ is a math waveform.
$ is a reference waveform.
specifies MATH1 as the immediate measurement source.
Examples
Group
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
