EasyManuals Logo

Tektronix TDS 620A User Manual

Tektronix TDS 620A
382 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #235 background imageLoading...
Page #235 background image
Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–217
"hello";STATE 1;BOX 74,84,475,135;:LOCK NONE; :HARDCOPY:FORMAT
EPSIMAGE;PORT GPIB;LAYOUT PORTRAIT;
*SRE
(Service Request Enable) sets and queries the bits in the Service Request Enable
Register (SRER). For a complete discussion of the use of these registers, see
page 3–1.
Status and Error
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMSg?, FACtory, *PSC, *STB?
*SRE <NR1>
*SRE?
?
<Space>
<NR1>
*SRE
<NR1> is a value in the range from 0 to 255. The binary bits of the SRER are set
according to this value. Using an out-of-range value causes an execution error.
The power-on default for SRER is 0 if *PSC is 1. If *PSC is 0, the SRER
maintains its value through a power cycle.
*SRE 48
sets the bits in the SRER to 00110000 binary.
*SRE?
might return a value of 32, showing that the bits in the SRER have the binary
value 00100000.
*STB? (Query Only)
(Read Status Byte) query returns the contents of the Status Byte Register (SBR)
using the Master Summary Status (MSS) bit. For a complete discussion of the
use of these registers, see page 3–1.
Status and Error
Group
Related Commands
Syntax
Arguments
Examples
Group

Table of Contents

Other manuals for Tektronix TDS 620A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS 620A and is the answer not in the manual?

Tektronix TDS 620A Specifications

General IconGeneral
BrandTektronix
ModelTDS 620A
CategoryTest Equipment
LanguageEnglish

Related product manuals