Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–219
TIMe <QString>
TIMe?
<QString>
TIMe
<Space>
?
<QString> is a date in the form hh:mm:ss".
hh refers to the hour number from 01 to 24.
mm refers to the minute number in the hour from 00 to 59.
ss refers to the seconds number in the minute from 00 to 59.
There must be a colon after the hh and after the mm.
Use two digits for each of the hh, mm, and ss.
TIME "01:24:00"
specifies that the time is set to 01:24 AM.
TRIGger
Forces a trigger event to occur, and the TRIGger query returns the current trigger
parameters.
Trigger
TRIGger FORCe
TRIGger?
TRIGger
FORCe
?
<Space>
FORCe creates a trigger event. If TRIGger:STATE is REAdy, the acquisition will
complete, otherwise this command will be ignored. This is equivalent to pressing
the front-panel FORCE TRIGGER button.
TRIGGER FORCe
forces a trigger event to occur.
TRIGGER?
might return :TRIGGER:MAIN:MODE AUTO;TYPE EDGE;LEVEL -480.0E-3;
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples