Tektronix TDS 620A - Page 247

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–229

 


 



 



 selects AC trigger coupling.
 selects DC trigger coupling.
 coupling removes the high frequency components of the DC signal.
 coupling removes the low frequency components of the AC signal.
  selects DC low sensitivity. It requires added signal amplitude for more
stable, less false triggering.
 
sets the main edge trigger coupling to DC.
TRIGger:MAIn:EDGE:SLOpe
Selects a rising or falling slope for the main edge trigger. This is equivalent to
setting Slope in the Trigger menu.
Trigger
  !  "  #
 



 






 specifies to trigger on the falling or negative edge of a signal.
 specifies to trigger on the rising or positive edge of a signal.
Arguments
Examples
Group
Syntax
Arguments