Program Examples
TDS Family Oscilloscope Programmer Manual
4–3
1'*&-
)*2 +/#%
4. For this installation, you will also want to copy and from
your Tektronix S3FG210 (National Instruments GPIB-PCII/IIA) GPIB
drivers directory to this directory. For example, if the GPIB drivers are in the
!*#3* directory and you are in the example programs directory, you
would type:
)*2 !*#*&"
)*2 !*#*'#)$
5. To compile and link your TDS sample C programs, simply type: ('%
#& (''%
where <file name> refers to the name of the example program you wish to
compile and link. Specifically:
To compile and link , type: ('% '-'%
To compile and link , type: ('% )'''%
To compile and link , type: ('% !.0 ''%
To compile and link , type: ('% /,-),'%
To compile and link , type: ('% .&'%
6. Run the program by simply typing the program name.
To run '-, type: '-
To run )'', type: )''
To run !.0 ', type: !.0 '
To run /,-),, type: /,-),
To run .&, type: .&
To make an executable for any of the following files, perform the following:
1. Install QuickBASIC.
2. Install the Tektronix S3FG210 (National Instruments GPIB-PCII/IIA) GPIB
board and drivers. Remember to reboot your PC to initialize the GPIB
drivers.
3. Copy the files from the examples diskette to your hard disk. You might also
create a special directory to store them. For example, if the current drive is
Compiling and Linking
Your Example
QuickBASIC Programs
To Next Page
Loading...
Need help?
General
