Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–47
RUNSTop specifies that the run and stop state should be determined by the user
pressing the front-panel RUN/STOP button.
SEQuence specifies “single sequence” operation, where the digitizing oscillo-
scope stops after it has acquired enough waveforms to satisfy the conditions of
the acquisition mode. For example, if the acquisition mode is set to sample, and
the horizontal scale is set to a speed that allows real-time operation, then the
digitizing oscilloscope will stop after digitizing a waveform from a single trigger
event. However, if the acquisition mode is set to average 100 waveforms, then
the digitizing oscilloscope will stop only after all 100 waveforms have been
acquired. The ACQuire: STATE command and the front-panel RUN/STOP
button will also stop acquisition when the digitizing oscilloscope is in single
sequence mode.
LIMit specifies the digitizing oscilloscope stops after the limit test condition is
met.
NOTE. If you set the acquisition system to single sequence, envelope mode, and
set the number of envelopes to infinity, the digitizing oscilloscope will envelope a
maximum of 2001 acquisitions.
ACQUIRE:STOPAFTER RUNSTop
sets the oscilloscope to stop acquisition when the user presses the front-panel
RUN/STOP button.
ACQUIRE:STOPAFTER?
might return SEQUENCE.
ALIas
Turns command aliases on or off. This command is identical to the
ALIas:STATE command.
Alias
ALIas { OFF | ON | <NR1> }
ALIas?
Arguments
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
