Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–181
MEASUrement:MEAS<X>:SOURCE2. This command is equivalent to setting
the direction in the Delay Edges & Direction side menu.
Measurement
$ !&'(&"! ) $% * $% +
$ !&'(&"!
$ !&
'
(
&"!
#
$%
$%
$% means that the search starts at the end of the waveform and looks for
the last rising or falling edge in the waveform. The slope of the edge is specified
by MEASUrement:MEAS<x>:DELay:EDGE2.
$% means that the search starts at the beginning of the waveform and
looks for the first rising or falling edge in the waveform. The slope of the edge is
specified by MEASUrement:MEAS<x>:DELay:EDGE2.
starts searching from the end of the waveform record.
might return for the search direction.
MEASUrement:MEAS<x>:DELay:EDGE1
Sets or queries the slope of the edge that is used for the delay “from” waveform
when taking a delay measurement. The waveform is specified by
MEASUrement:MEAS<x>:SOURCE1. This command is equivalent to selecting
the edges in the Delay Edges & Direction side menu.
Measurement
$ !&'( ) * +
Group
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
