Tektronix TDS 684A - Page 200

Command Descriptions
2–182
TDS Family Oscilloscope Programmer Manual
 












 specifies the falling edge.
 specifies the rising edge.
 
specifies that the rising edge be used for measurement 3.

returns either  or  for measurement 1.
MEASUrement:MEAS<x>:DELay:EDGE2
Sets or queries the slope of the edge that is used for the delay “to” waveform
when taking a delay measurement. The waveform is specified by
MEASUrement:MEAS<x>:SOURCE2. This command is equivalent to selecting
the edges in the Delay Edges & Direction side menu.
Measurement
  !  "  #
 












 specifies the falling edge.
Arguments
Examples
Group
Syntax
Arguments