Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–183
specifies the rising edge.
specifies that the rising edge be used for the second delay measurement.
might return showing that the falling or negative edge of the waveform is
used for the second measurement.
MEASUrement:MEAS<x>:SOURCE[1]
Sets or queries the source for all single channel measurements and specifies the
source to measure “from” when taking a delay measurement or phase measure-
ment.
Measurement
!"# $ # % # % #&
!"#
#
!"
#
# is an input channel.
# is a math waveform.
# is a reference waveform.
specifies MATH1 as the measurement 2 source.
Examples
Group
Syntax
Arguments
Examples