Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–67
CH4:PROBE?
might return 100.0E-3 for a 10x probe.
CH<x>:PROBECal? (Query Only)
TDS 500B, 600B, & 700A
Queries the probe cal status for the selected channel.
Vertical
CH<x>:PROBECal?
?
PROBECal
CH
:<x>
FAIl signifies that probe cal has failed for the selected channel.
INIT signifies the probe cal has not yet been run for the selected channel
PASS signifies that probe cal has passed for the selected channel.
CH2:PROBECAL?
might return PASS indicating that probe cal has passed for channel 2.
CH<x>:SCAle
Sets or queries the vertical gain of the specified channel. This is equivalent to
setting Fine Scale in the Vertical menu or adjusting the front-panel Vertical
SCALE knob.
Vertical
CH1:VOLts
CH<x>:SCAle <NR3>
CH<x>:SCAle?
Examples
Group
Syntax
Outputs
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
