Command Descriptions
2–66
TDS Family Oscilloscope Programmer Manual
CH<x>:POSition
Sets or queries the vertical position of the specified channel. The position value
is applied to the signal before digitization. This is equivalent to setting Position
in the Vertical menu or adjusting the front-panel Vertical Position knob.
Vertical
CH<x>:OFFSet
CH<x>:POSition <NR3>
CH<x>:POSition?
POSition
CH
<x>
:
?
<Space> <NR3>
<NR3> is the desired position, in divisions from the center graticule. The range is
±5 divisions.
CH2:POSITION 1.3E+00
positions the channel 2 input signal 1.3 divisions above the center of the display.
CH1:POSITION?
might return -1.3E+00, indicating that the current position of channel 1 is at
–1.3 divisions.
CH<x>:PROBE? (Query Only)
Returns the attenuation factor of the probe that is attached to the specified
channel.
Vertical
CH<x>:PROBE?
CH
<x> :
PROBE
?
<NR3>
Group
Related Commands
Syntax
Arguments
Examples
Group
Syntax
Returns
To Next Page
Loading...
