Command Descriptions
2−88
TDS200/1000/2000 Series Oscilloscope Programmer Manual
HARDCopy
Sends a copy of the screen display followed by an EOI to the port
specified by HARDCopy:PORT. The format and layout of the output
is specified with the HARDCopy:FORMat and HARDCopy:LAYout
commands. This command is equivalent to pressing the PRINT
button on the front panel of the TDS1000 and TDS2000 series or the
HARDCOPY button on the front panel of the TDS200 series.
HARDCopy? returns format, layout, and port information.
NOTE. This command is not IEEE Std 488.2–1987 compatible.
Hard copy
HARDCopy { ABOrt | STARt }
HARDCopy?
ABOrt terminates the hard copy output in process.
NOTE. DCL does not clear the output queue once a hard copy is in
process. The only way to abort the hard copy process is to send the
HARDCopy ABOrt command. The output queue can then be cleared
by sending a DCL message.
STARt initiates a screen copy that is sent to the port specified by the
HARDCOPY:PORT command.
Group
Syntax
Arguments
To Next Page
Loading...
