Tektronix TDS200 Series - Page 110

Command Descriptions
2−92
TDS200/1000/2000 Series Oscilloscope Programmer Manual
HARDCopy:LAYout { LANdscape | PORTRait }
HARDCopy:LAYout?
LANdscape specifies that the bottom of the hard copy is along the
long side of the piece of paper.
PORTRait specifies that the bottom of the hard copy is along the
short side of the piece of paper. This is the standard format.
HARDCopy:LAYout?
might return PORTRAIT as the page layout format of the hard copy
output.
HARDCopy:PORT
Selects where to send the hard copy data when the oscilloscope
receives the next HARDCOPY STARt command. This command is
equivalent to setting the Port option in the UTILITY " Options "
Hard Copy Setup menu.
Hard copy
HARDCopy:PORT { CENtronics | RS232 | GPIb }
HARDCopy:PORT?
CENtronics specifies that the hard copy data is sent out the
Centronics port.
RS232 specifies that the hard copy data is sent out the RS232 port.
GPIb specifies that the hard copy data is sent out the GPIB port.
Syntax
Arguments
Examples
Group
Syntax
Arguments