Command Descriptions
2−98
TDS200/1000/2000 Series Oscilloscope Programmer Manual
HORizontal:MAIn:POSition
Sets or queries the main time base horizontal position. This
command is equivalent to adjusting the Horizontal Position when
Main is selected from the Horizontal menu.
Horizontal
HORizontal:MAIn:POSition <NR3>
HORizontal:MAIn:POSition?
<NR3> is the position in seconds. This value is the difference between
the trigger point and the center graticule. Positive values place the
trigger before the center graticule.
HORizontal:MAIn:POSition 2.0E–6
sets the main trigger position to 2 ms before the center graticule.
HORizontal:MAIn:POSition?
might return –1.0E–3, indicating that the main trigger position is 1
ms after the center graticule.
HORizontal:MAIn:SCAle
Sets the time per division for the main time base. This command is
equivalent to setting SEC/DIV when Main is selected from the
Horizontal menu.
Horizontal
Group
Syntax
Arguments
Examples
Group
To Next Page
Loading...
