Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−155
SAVE indicates that acquisition is stopped or that all channels are off.
SCAN indicates that the oscilloscope is in scan mode.
TRIGger:STATE?
might return READY, indicating that pretrigger data has been acquired
and the oscilloscope is waiting for a trigger.
*OPC?
*TST? (Query Only)
(Self-Test) Tests the GPIB interface and always returns a 0.
Miscellaneous
*TST?
0
UNLock (No Query Form)
Unlocks the front panel. This command is equivalent to LOCk
NONe.
NOTE. If the oscilloscope is in the Remote With Lockout State
(RWLS), the UNLock command has no effect. For more information
refer to ANSI-IEEE Std. 488.1–1987, Standard Digital Interface for
Programmable Instrumentation, section 2.8.3, on RL State
descriptions.
Examples
Related Commands
Group
Syntax
Returns
To Next Page
Loading...
