Tektronix TDS200 Series - Page 179

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−161
DATa:WIDth
WFMPre:BYT_Or
Sets or queries which byte of binary waveform data is transmitted
first during a waveform data transfer when DATa:WIDth or
WFMPre:BYT_Nr is set to 2, or WFMPre:BIT_Nr is set to 16.
Changing WFMPre:BYT_Or changes DATa:ENCdg.
Waveform
WFMPre:BYT_Or { LSB | MSB }
WFMPre:BYT_Or?
LSB selects the least significant byte to be transmitted first.
MSB selects the most significant byte to be transmitted first.
WFMPre:BYT_Or MSB
specifies that the most significant byte in the waveform data is
transferred first.
WFMPre:BYT_Or?
returns either MSB or LSB depending on which data byte is transferred
first.
DATa:ENCdg
Related Commands
Group
Syntax
Arguments
Examples
Related Commands