Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−85
<NR1>
EVENT?
might return the response :EVENT 110, showing that there was an
error in a command header.
ALLEv?, *CLS, DESE, *ESE, *ESR?, EVMsg?, *SRE, *STB?
EVMsg? (Query Only)
Removes from the Event Queue a single event code associated with
the results of the last *ESR? read, and returns the event code along
with an explanatory message. Refer to Event Handling Sequence on
page 3-8 for for more information.
Status and Error
EVMsg?
The event code and message in the following format:
<Event Code><Comma><QString>[<Event Code><Comma>
<QString>...]
<QString>::= <Message>;[<Command>]
where <Command> is the command that caused the error and may
be returned when a command error is detected by the oscilloscope.
As much of the command as possible is returned without exceeding
the 60 character limit of the <Message> and <Command> strings
combined. The command string is right-justified.
Returns
Examples
Related Commands
Group
Syntax
Returns
To Next Page
Loading...
