Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−59
CURSor:HBArs?
Current horizontal bar cursor settings.
CURSor:HBArs?
might return CURSOR:HBARS:UNITS VOLTS;POSITION1 0.0E0;
POSITION2 0.0E0
CURSor:HBArs:DELTa? (Query Only)
Returns the difference (in vertical units) between the two horizontal
bar cursors in the oscilloscope display.
NOTE. If Trigger View is active, this query returns 9.9E37 and
generates event 221 (Settings conflict).
Cursor
CURSor:HBArs:DELTa?
<NR3>
CURSor:HBArs:DELTa?
might return 5.08E0 for the difference between the two cursors.
CURSor:HBArs:POSITION<x>
Positions a horizontal bar cursor.
Syntax
Returns
Examples
Group
Syntax
Returns
Examples
To Next Page
Loading...
