Command Descriptions
2−62
TDS200/1000/2000 Series Oscilloscope Programmer Manual
CURSor:SELect:SOUrce?
<wfm> specifies the waveform data source on which cursor
measurements will be taken.
CURSor:SELect:SOUrce CH1
selects channel 1.
CURSor:SELect:SOUrce?
might return MATH
CURSor:VBArs? (Query Only)
Returns the current vertical bar cursor horizontal position and units
settings.
Cursor
CURSor:VBArs?
CURSor:VBArs?
might return CURSOR:VBARS:UNITS SECONDS;
POSITION1 1.00E–6;POSITION2 9.00E–6
CURSor:VBArs:DELTa? (Query Only)
Returns the time or frequency difference between the two vertical
bar cursors. The units (seconds or Hertz) are specified by the
CURSor:VBArs:UNIts command. If the cursor source is an FFT
math waveform, CURSor:VBArs:DELTa is always in Hertz,
regardless of the value set by CURSor:VBArs:UNIts.
Arguments
Examples
Group
Syntax
Examples
To Next Page
Loading...
