Tektronix TDS2012 - Page 81

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−63
NOTE . If Trigger View is active, this query returns 9.9E37 and
generates event 221 (Settings conflict).
Cursor
CURSor:VBArs:DELTa?
<NR3>
CURSor:VBArs:DELTa?
might return 8.92E–1, indicating that the time difference between
the vertical bar cursors is 0.892 seconds.
CURSor:VBArs:POSITION<x>
Positions a vertical bar cursor. The unit is specified by the
CURSor:VBArs:UNIts command, and can be in units of seconds or
frequency (Hertz). If the cursor source is an FFT math waveform,
CURSor:VBArs:POSITION is always in Hertz, regardless of the
value set by CURSor:VBArs:UNIts.
NOTE. If Trigger View is active, the query form returns 9.9E37 and
generates event 221 (Settings conflict).
Cursor
CURSor:VBArs:POSITION<x> <NR3>
Group
Syntax
Returns
Examples
Group
Syntax