Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−69
Waveform
DATa:ENCdg { ASCIi | RIBinary | RPBinary | SRIbinary |
SRPbinary }
DATa:ENCdg?
ASCIi specifies the ASCII representation of signed integer
(RIBinary) data. If this is the value at power-on, the WFMPre values
for BN_Fmt, BYT_Or, and ENCdg are set as RP, MSB, and ASC
respectively.
RIBinary specifies signed integer data-point representation with the
most significant byte transferred first. This format results in the
fastest data transfer rate when DATa:WIDth is set to 2.
The range is –128 to 127 when DATa:WIDth is 1. Zero is center
screen. The range is –32768 to 32767 when DATa:WIDth is 2. The
upper limit is one division above the top of the screen and the lower
limit is one division below the bottom of the screen.
RPBinary specifies positive integer data-point representation with
the most significant byte transferred first.
The range is 0 to 255 when DATa:WIDth is 1. Center screen is 127.
The range is 0 to 65,535 when DATa:WIDth is 2. The upper limit is
one division above the top of the screen and the lower limit is one
division below the bottom of the screen.
SRIbinary is the same as RIBinary except that the byte order is
swapped, meaning that the least significant byte is transferred first.
This format is useful when transferring data to IBM compatible PCs.
SRPbinary is the same as RPBinary except that the byte order is
swapped, meaning that the least significant byte is transferred first.
This format is useful when transferring data to IBM compatible PCs.
Table 2-24 lists DATa and WFMPre parameter settings.
Group
Syntax
Arguments
To Next Page
Loading...
