Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−73
DATa:STOP 150
specifies that the waveform transfer will stop at data point 150.
DATa:STOP?
might return 285 as the last data point that will be transferred.
CURVe?
DATa:TARget
Sets or queries the location for storing waveform data transferred
from an external device to the oscilloscope when executing the
CURVe command. This command is equivalent to the DATa:DES-
Tination command and is included here for compatibility with older
Tektronix oscilloscopes.
DATa:WIDth
Sets the number of bytes per waveform data point to be transferred
when executing the CURVe command. (Changing DATa:WIDth may
change the following WFMPre parameters: BIT_Nr, BYT_Nr,
YMULt, YOFf, and YZEro.)
Waveform
DATa:WIDth <NR1>
DATa:WIDth?
<NR1> = 1 sets the number of bytes per waveform data point to 1
byte (8 bits).
Examples
Related Commands
Group
Syntax
Arguments
To Next Page
Loading...
