Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−77
DIAg:RESUlt:LOG? (Query Only)
Returns the internal results log from the last diagnostic test sequence
execution (those run automatically at power on, or those requested
through the Service Menu). The list contains all modules and module
interfaces that were tested along with the pass or fail status of each.
Calibration and Diagnostic
DIAg:RESUlt:LOG?
<QString> in the following format:
<Status>,<Module name>[,<Status>,<Module name>...]
DIAg:RESUlt:LOG?
might return pass−CPU, pass−ACQ1, pass−EXTENSION" for
power-up diagnostics.
DISplay? (Query Only)
Returns the current display settings.
Display
DISplay?
The current display settings
Group
Syntax
Returns
Examples
Group
Syntax
Returns
To Next Page
Loading...
